HP Point of Sale rp5000 Hardware Reference Guide (2nd Edition) - Page 43

Powered Serial Port Configuration

Get HP Point of Sale rp5000 PDF manuals and user guides View all HP Point of Sale rp5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

B Powered Serial Port Configuration The four serial ports on the HP Point of Sale System rp5000 can be configured as either standard (non-powered) serial ports or powered serial ports. Some Point of Sale devices use a powered serial port. If the serial port is configured as a powered port, devices that support a powered serial interface do not require an external power source. ✎ The computer ships with the serial ports configured in standard mode. Each serial port has two red jumpers. In powered serial port mode, one jumper provides 5 volts to the Ring Indicate (RI) pin on the serial connector. The other jumper provides 12 volts to the Data Carrier Detect (DCD) serial connector pin. When configuring the port, both jumpers must be moved to either the powered or standard configuration position. To configure the serial ports: 1. Turn off the computer properly through the operating system, then turn off any external devices. 2. Disconnect the power cord from the power outlet and disconnect any external devices. 3. Remove the computer access panel and front bezel (see Chapter 2, "Removing the Computer Access Panel and Front Bezel"). 4. Raise the Easy Access drive bay to the upright position to access the system board. Hardware Reference Guide www.hp.com B-1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Hardware Reference Guide
www.hp.com
B-1
B
Powered Serial Port Configuration
The four serial ports on the HP Point of Sale System rp5000 can be
configured as either standard (non-powered) serial ports or powered
serial ports. Some Point of Sale devices use a powered serial port. If
the serial port is configured as a powered port, devices that support a
powered serial interface do not require an external power source.
✎
The computer ships with the serial ports configured in standard mode.
Each serial port has two red jumpers. In powered serial port mode,
one jumper provides 5 volts to the Ring Indicate (RI) pin on the serial
connector. The other jumper provides 12 volts to the Data Carrier
Detect (DCD) serial connector pin. When configuring the port, both
jumpers must be moved to either the powered or standard
configuration position.
To configure the serial ports:
1. Turn off the computer properly through the operating system,
then turn off any external devices.
2. Disconnect the power cord from the power outlet and disconnect
any external devices.
3. Remove the computer access panel and front bezel (see Chapter
2,
“Removing the Computer Access Panel and Front Bezel”).
4. Raise the Easy Access drive bay to the upright position to access
the system board.