HP ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance an - Page 116
FYI: Drive bay X is, Inspect Utility. If
View all HP ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
3-62 Diagnostic Tools DAAD Diagnostic Messages Continued Message Description Drive (bay) X RIS The copies of the RIS on this copy mismatch drive do not match. Drive (bay) X upload code not readable Duplicate write memory error Error occurred reading RIS copy from drive (bay) X FYI: Drive (bay) X is non-Compaq supplied Identify controller data did not match with NVRAM Identify logical drive data did not match with NVRAM Insufficient An error occurred while DAAD was trying to read the upload code information from this drive. Data could not be written to the array accelerator board in duplicate due to the detection of parity errors. This is not a data loss situation. An error occurred while DAAD was trying to read the RIS from this drive. The installed drive was not supplied by Compaq. The identify controller data from the array controller did not match with the information stored in nonvolatile RAM. This could occur if new, previously configured drives have been placed in a system that has also been previously configured. It could also occur if the firmware on the controller has been upgraded and the System Configuration Utility was not run. The identify unit data from the array controller did not match with the information stored in nonvolatile RAM. This could occur if new, previously configured drives have been placed in a system that has also been previously configured. The adapter does not have Recommended Action This drive may need to be replaced. Check for other errors. If there were multiple errors, this drive may need to be replaced. Replace the array accelerator board. If there were multiple errors, this drive may need to be replaced. If problems exist with this drive, replace it with a Compaq drive. Check the identify controller data under the Inspect Utility. If the firmware version field is the only thing different between the controller and nonvolatile RAM data, this is not a problem. Otherwise run the System Configuration Utility. Run the System Configuration Utility to configure the controller and nonvolatile RAM. Operate the system without