HP ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance an - Page 43
Processors, Compaq ProLiant 1600
View all HP ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
2-25 Processors Compaq ProLiant 1600 To remove the Compaq ProLiant 1600 processor: IMPORTANT: If a single processor is installed, a terminator board must be installed (Compaq ProLiant 1600 only). 1. Perform the preparation procedures. See page 2-2. 2. Remove the processor cage (see page 2-21) and open the cage door. 3. Remove the Pentium II adapter board and place it on a non-conductive work surface. See page 2-23. 4. Push in the latches on each side of the processor until you hear two clicks . This locks the tabs in the open position. 5. Slide the processor from the Pentium II adapter board . 1 2 1 Figure 2-22. Removing the Processor from the Compaq ProLiant 1600 Server Reverse steps 1 through 5 to replace the Compaq ProLiant 1600 processor. Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide