HP ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance an - Page 120
DRIVE REPLACED, will occur.
View all HP ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
3-66 Diagnostic Tools DAAD Diagnostic Messages Continued Message Description Logical Drive X A physical drive in this logical status = WRONG drive has failed. The incorrect DRIVE REPLACED drive was replaced. Loose cable detected - logical drives may be marked FAILED until corrected Mirror data miscompare Mirrored memory location errors No configuration for Accelerator Board Controller unable to communicate with one or more physical drives, probably because of a cabling problem. Logical drives may be in a FAILED state until the condition is corrected, preventing access to data on the controller. Data was found at reinitialization in the posted write memory; however, the mirror data compare test failed resulting in data being marked as invalid. Data loss is possible. Soft errors occurred when attempting to read the same data from both sides of the mirrored memory. Data loss will occur. The array accelerator board has not been configured. Drive (bay) X has loose cable The array controller could not communicate with this drive at power-up. This drive has not previously failed. Recommended Action Replace the drive that was incorrectly replaced. Then, replace the original drive that failed with a new drive. Do not run the System Configuration Utility to reconfigure; you will lose data on the drive. Check all controller and drive cable connections. Replace the array accelerator board. Replace the array accelerator board. If the array accelerator board is present, run the System Configuration Utility to configure the board, if desired. Check all cable connections first. The cables could be bad, loose, or disconnected. Turn on the system and attempt to reconnect data/power cable to the drive. If this does not work, replace the