HP ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance an - Page 54
External Replacement Battery, Do not remove the lithium battery from
View all HP ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
2-36 Removal and Replacement Procedures External Replacement Battery CAUTION: Do not remove the lithium battery from the system I/O board or permanent damage may occur. If the battery fails, use the external replacement battery. To install the external replacement battery: 1. Perform the preparation procedures. See page 2-2. 2. Remove the top cover. See page 2-9. 3. Connect the replacement battery to the battery header on the system I/O board. 4. Move the jumper on connector E2 from pins 1 and 2 to pins 2 and 3. Figure 2-33. Installing the External Replacement Battery 5. Remove the adhesive backing from the hook-and-loop fastener strip. Place the battery and the hook-and-loop fastener strip as indicated in the following illustration. 6. Place the sticker included with your battery kit on the back of your server above the power connector. 7. Run the System Configuration utility to reconfigure the server.