HP Surestore L10 Service and User Manual (Short- and Long-Wave) - Page 42
Procedure 7: Verify the Connections
View all HP Surestore L10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Procedure 7: Verify the Connections After connecting devices and the server to the hub, verify the connections. Note Because the hub is strictly a pass-through device for FC-AL traffic, there is no hub address and the hub is not listed in ioscan output (HP-UX servers) or the SCSI Adapters window (HP NetServers). For HP-UX servers: 1. Use the following HP-UX command to run ioscan and check the hardware paths between the server and the attached FC-AL devices: ioscan -f For details on ioscan and its options, refer to the HP-UX System Administration Tasks Manual. Also consult the device documentation to interpret the ioscan output. 2. If the Hardware State of a device connected to the hub is "Unclaimed"or "No H/W,"see chapter 4, Troubleshooting, for more information. For HP NetServers: 1. From the Start menu, select Settings, then select Control Panel. 2. Double-click the SCSI Adapters icon. The SCSI Adapters window appears. 3. Click the Devices tab, then verify that the FC-AL devices connected to the hub are displayed. 40 Procedure 7: Verify the Connections