HP Visualize J5000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 71

Troubleshooting Identifying LCD-Indicated Conditions Table 3-1. Chassis Codes for J5xxx and J7xxx Workstations Ostat FLT FLT INI TST TST INI WRN FLT TST WRN TST TST TST TST TST TST TST TST TST TST WRN FLT FLT Code FRU 7309 DIMM 730C 730F 7400 740F 7500 7501 7502 SYS BD SYS BD DIMM DIMM SYS BD SYS BD SYS BD 7600 7601 DIMM DIMM 7602 7603 7604 DIMM DIMM DIMM 7605 7606 DIMM DIMM 7607 7608 DIMM DIMM 7609 760A DIMM DIMM 760B 760C DIMM DIMM 760D DIMM 7610 DIMM Message Description insufficient mem Insufficient error-free memory to continue. mem intrlv fail Memory interleave generation failed. mem config done Main memory configuration complete. non-dest mem tst Starting non-destructive memory test. non-dst tst done Non-destructive memory test complete. memory reset Resetting memory system. mem log clr warn Memory error logs didn't clear on first try. mem err log fail Firmware could not clear memory error logs. dest mem test Starting the destructive memory test. mem init only Skip the test, just initialize memory to save time. tst 1st mem page Starting 3-pass test of first memory page. tst rest of mem Starting 3-pass test of the rest of memory. start 1st pass Starting 1st pass of memory test (write pseudorandom sequence). 1st pass x% First pass is x% complete. start 2nd pass Starting 2nd pass of memory test (verify pseudorandom sequence, write inverse). 2nd pass x% Second pass is x% complete. start 3rd pass Starting 3rd pass of memory test (verify inverse sequence). 3rd pass x% Third pass is x% complete. start mem init Starting memory initialization. (Initialize to zero to set ECC.) mem init x% Memory initialization is x% complete. repeat dest test Re-execute destructive test for hardware troubleshooting. mem code cpy err Firmware tried to copy code from ROM to memory, but the copy didn't match the original. ECC wrt/read err Writing and reading back good data caused memory ECC error. Chapter 3 65