HP ap5000 Hardware Reference Guide HP ap5000 All-In-One Point of Sale System - Page 30
WARNING, Removing the Display Head Screws
View all HP ap5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
9. Remove the five screws that secure the display head to the display head housing. Two of the screws are located under the bottom I/O cover. The third screw is located under the drive cover. The fourth screw is located under the MSR. The fifth screw is located below the touch screen hinge. NOTE: Some models may have only four screws. The center screw shown below may not be included. Figure 2-27 Removing the Display Head Screws 10. Lift the bottom side of the display head housing (where the two screws were removed) off the touch screen (1), then lift the top side off the housing off the touch screen (2). Figure 2-28 Removing the Display Head 11. Locate the memory module sockets on the system board. WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system components to cool before touching. 24 Chapter 2 Hardware Upgrades ENWW