Hitachi CJ110MV Instruction Manual - Page 12

English (2) For the hard material, such as a steel plate, etc., decrease the orbital operation. For the soft material, such as lumber, plastic, etc., increase the orbital operation to increase work efficiency. To cut the material accurately, decrease the orbital operation. 9. Cutting stainless steel plates This Jig Saw can cut stainless steel plates by using No. 97 blade. Carefully read "Concerning cutting of stainless steel plates" for proper operation. 10. Splinter guard (Sold separately) Using the splinter guard when cutting wood materials will reduce splintering of cut surfaces. Insert the splinter guard in the space on the base, and push it completely. (see Fig. 8) 11. Chip cover (Sold separately) Chip cover prevents chips from flying off and improves the efficiency of dust collector (Sold separately). Insert the chip cover between the base and lever, and push with a slight pressure until it catches in place. (Fig. 9) When removing chip cover, hold both sides of knob and slightly open until it can be removed from the Jig Saw. Change knob Fig. 7 Splinter guard Fig. 8 Lever Chip cover Base NOTE: There is a possibility that chip cover is frosted when cutting the metal. 12. Sub base (Sold separately) Using the sub base (made from steel) will reduce abrasion of aluminium base especially in cutting metals. Using the sub base (made from resin) will reduce scratching of cut surface. Attach the sub base to the bottom surface of base by attached 4 screws. 13. Lighting up the lamp Fig. 9 Base CAUTION: Do not look in the light or see the source of light directly. To turn on the lamp, pull the trigger. Release the trigger to turn off. 12