Hitachi NV45AE Instruction Manual - Page 13

Magazine Nail holder For 7/8", 1" and 1-1/4" (22 mm, 25 mm, 32 mm) 3 For 1-1/2" (38 mm) For 1-3/4" (45 mm) 1 2 Plate NOTE: Before loading nails in the magazine, adjust the nail holder. If the magazine cover is forcibly closed without adjusting the nail holder correctly, the nail holder may be damaged. (3) Place the nail coil in the magazine. Insert the first nail into the magazine opening. Magazine opening Magazine English guide and knob, turn the nail guide clockwise while pressing the knob downward, and then close the nail guide completely. Knob 4 4 Nail guide (6) Lock the knob completely. Magazine cover The Nailer is now ready to operate. (1) Press the magazine stopper and open the magazine cover. First nail Nail (4) Close the magazine cover. (5) 1 2 3 Uncoil enough nails to reach the driving hole. Insert the first nail into the driving hole and the second nail between the two pawls of the feeder. Fit the nail heads in the guide slot. Driving hole Guide surface Guide slot First nail 23 1 4 Magazine cover Magazine stopper (2) Adjust the position of the nail holder according to the nail length. The nail will not feed smoothly if the nail holder is not correctly adjusted. 1 Turn the nail holder about 90 degrees counterclockwise. 2 Move the nail holder up and down to align the top of the nail holder with a mark on the holder shaft in accordance with the length of the nails being used. 3 Turn the nail holder 90 degrees clockwise until you hear "click". For 1-1/4" For 7/8" and 1" For 1-1/2" and 1-3/4" Magazine cover Nail guide 2 Pawl Feeder NOTE: Be careful not to deform the collated wires and not to disengage the nails with the guide surface. Mark Otherwise, the nail guide will not close correctly. Nail holder 4 Pulling the nails to the right After checking and making sure that the magazine cover is closed, hook your fingers on the nail NOTE: Before loading nails in the magazine, adjust the nail holder. If the magazine cover is forcibly closed without adjusting the nail holder correctly, the nail holder may be damaged. - 13 -