Honeywell HW1000i Owners Manual - Page 24
Engine Oil, Engine Oil Recommendations, Checking Engine Oil Level
UPC - 894190002186
View all Honeywell HW1000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Engine Oil Engine Oil Engine Oil NOTICE Engine oil is a major factor affecting engine performance and service life. NEVER use non-detergent and 2-stroke engine oils. • Be sure to use engine oils specified under "Engine Oil Recommendations." It is very important to maintain proper level of engine oil to keep engine in good running condition. • Check engine oil level prior to each use. Refill engine oil if oil level is low. Engine Oil Recommendations Use 4-stroke oil, or equivalent high detergent, premium quality motor oil certified to meet or exceed U.S. automobile manufacturer's requirements for API Performance Class SF or better. SAE 15W-40 is recommended for general, all-temperature use. 5. Remove the oil fill cap. FIGURE 18: Oil Fill Cap Removal (HW2000i Model) 6. Check the oil level is up to the innermost thread of the crankcase. 15W-40 FIGURE 17: Recommended Oil Viscosity Checking Engine Oil Level To check engine oil level: 1. Stop the generator if the engine is running. WARNING ALWAYS stop engine before removing the oil fill cap. Crankcase pressure can cause hot engine oil to spray out of engine fill hole. Hot engine oil can cause severe burns. 2. Place the generator on a flat, level surface. 3. Remove the back maintenance cover using the Phil- lips end of the universal screwdriver bit. 4. Using a clean cloth, wipe around the oil fill cap area to remove dirt and debris. FIGURE 19: Oil Fill Measurement To add engine oil: 7. During initial fill or when the oil level is low, add oil (see "Engine Oil Recommendations") to the oil fill container (included). DO NOT OVERFILL. HW1000i Oil Capacity [qt / ml] 0.26 / 250 TABLE 4. Engine Oil Capacity HW2000i 0.48 / 450 18 www.honeywellgenerators.com HW1000i / HW2000i Inverter Generator Owner's Manual