Hoover FH50240RM Product Manual - Page 14

Cleaning, Upholstery

Page 14 highlights

CLEANING UPHOLSTERY Read "Before You Begin Cleaning" instructions on page 9. Be sure to check the cleaning code on your upholstery. Use your cleaner only on upholstery marked "W" or "W/S". Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. Fill Clean Water Tank according to instructions for Fig. 2.9. Fill detergent container with HOOVER® detergent according to instructions for Fig. 2.10. Do not use hard floor cleaning solution when cleaning upholstery. Attach tool to end of hose. Do not point tools toward people or pets. Dry hands and plug cleaner into a properly grounded outlet. Set Wash/Rinse Setting switch to WASH. Turn cleaner ON. 4.6 Gently press the tool onto the fabric. Press the trigger and slowly pull the nozzle over the fabric. Overlap strokes by 1/2 inch to help prevent streaking. Make additional strokes without pressing the trigger to remove more moisture. To clean in corners or creases, lift the tool one half inch from the fabric and press the solution trigger. Vacuum up the solution with the tool without pressing the trigger. 4.6 4.7 For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass. Make no more than 2 passes with the solution over any one area to prevent over-wetting and damage to fabric. If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic Shut-Off', Fig. 2.19). When finished cleaning, empty Clean Water Tank, wash and rinse dirty Water Tank and let air dry. See "After Cleaning" section (Page. 12) for additional information. Actualmodelmay vary from images shown. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38

CLEANING
UPHOLSTERY
Read
"Before
You
Begin
Cleaning"
instructions
on
page
9.
Be
sure
to
check
the
cleaning
code
on
your
upholstery.
Use
your
cleaner
only
on
upholstery
marked
"W"
or
"W/S".
Place
handle
in
upright
position.
Agitator
brushes
will
not
rotate
while
handle
is
in
upright
position.
Fill
Clean
Water
Tank
according
to
instructions
for
Fig.
2.9.
Fill
detergent
container
with
HOOVER®
detergent
according
to
instructions
for
Fig.
2.10.
Do
not
use
hard
floor
cleaning
solution
when
cleaning
upholstery.
Attach
tool
to
end
of
hose.
Do
not
point
tools
toward
people
or
pets.
Dry
hands
and
plug
cleaner
into
a
properly
grounded
outlet.
Set
Wash/Rinse
Setting
switch
to
WASH.
Turn
cleaner
ON.
4.6
Gently
press
the tool
onto
the
fabric.
Press
the
trigger
and
slowly
pull
the
nozzle
over
the
fabric.
Overlap
strokes
by
1/2
inch
to
help
prevent
streaking.
Make
additional
strokes
without
pressing
the
trigger
to
remove
more
moisture.
To
clean
in
corners
or
creases,
lift
the tool
one
half
inch
from
the
fabric
and
press
the
solution
trigger.
Vacuum
up
the
solution
with
the
tool
without
pressing
the
trigger.
4.6
4.7
For
heavily
soiled
areas,
it
may
be
necessary
to
repeat
the
cleaning
process.
Make
crisscrossing
strokes
to
the
original
pattern;
overlap
each
pass.
Make
no
more
than
2
passes
with
the
solution
over
any
one
area
to
prevent
over
-wetting
and
damage
to
fabric.
If
additional
cleaning
is
necessary,
wait
until
the
upholstery
is
completely
dry
before
using
the
tool
again.
Empty
Dirty
Water
Tank
when
the
motor
sound
becomes
higher
pitched
and
there
is
a
loss
in
suction
(see
"Automatic
Shut
-Off',
Fig.
2.19).
When
finished
cleaning,
empty
Clean
Water
Tank,
wash
and
rinse
dirty
Water
Tank
and
let
air
dry.
See
"After
Cleaning"
section
(Page.
12)
for
additional
information.
Actual
model
may
vary
from
images
shown.
14