Hoover S3630 Manual - Page 8
Filters, secondary and micro, Belt replacement - replacement parts
View all Hoover S3630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3 - 2 3 - 3 3-4 B A Carefully pull out used bag. 3 - 5 Form new bag into a box-like shape. Slide bag collar firmly into holder. 3 - 6 Push rear edge of bag into bag cavity below seal (A). Clear bag opening (B) by pushing the pierced paper through opening toward bag interior. Close bag lid. 3 - 7 How to attach bag lid The bag lid and hinges are designed with a "break- away" feature. If the lid is pushed open too far, it will come off. It can be easily re-attached by aligning the hinges with the appropriate slots in the cleaner, as shown. 3 - 8 If filter is dirty, open grid on cassette and remove filter. Wash filter in warm water or replace it with a new one. A dry filter must be put back into cleaner. 8 Filterssecondary and micro How to clean Disconnect cleaner from electrical outlet. The secondary filter, located behind the grill in the bag compartment, protects the motor from dirt particles. If filter becomes dirty, pull off grill and lift out filter. Wash filter in warm water or replace it with a new one. A dry filter must be put back into cleaner. Do not operate cleaner without secondary filter in place. Belt replacement The belt in your power nozzle drives the agitator. It has been designed specifically for use in this cleaner and is important for effective operation. What to buy There are other belts manufactured that are similar in shape and size, but are not designed for the HOOVER power nozzle. Such belts do not operate the agitator correctly and may create stress which could damage your power nozzle. Use only a genuine HOOVER Belt part no. 40201180 when a belt replacement is necessary. The micro filter aids in the filtration process to return clean air to the room. To remove this filter, open tool lid, remove dusting brush and pull up red filter cassette. When to replace The belt should be checked from time to time to be sure it is in good condition. To check, remove the hood (see following section). Replace the belt if it is stretched, cut, or broken.