Hoover S3630 Manual - Page 9

3 - 9 3 - 1 0 3 - 1 1 C How to replace Disconnect cleaner from electrical outlet and disconnect power nozzle from extension wands. To remove hood, turn nozzle over and unscrew the 4 recessed Phillips head screws. Note: Do not remove the 3 screws in the triangle formation as these hold the motor in place. 3 - 1 2 Return nozzle to original position and lift off hood. Remove brush roll cover (C) by removing the 3 Phillips head screws. 3 - 1 3 3-14 E C Lift off brush roll cover (C). 3 - 1 5 D If belt is not broken but is stretched or cut, pull it off the motor pulley (D). Lift up end of agitator brush roll. Remove old belt from agitator pulley (E) and replace with new belt. Lettering on belt must be visible. 3 - 1 6 3 - 1 7 F Stretch belt back and attach to motor pulley. Hold opposite end of agitator brush roll in place. Push belt end forward, rotating end plate (F) until it slides into place. Turn agitator, making sure it rotates freely. C Replace brush roll cover over agitator brush roll. Replace 3 short screws. Position hood on top of nozzle base. Turn nozzle over. Replace 2 short screws at the back of nozzle and 2 long screws at the front. 9