Husqvarna 130L Owner Manual - Page 17

To replace the trimmer line (130L) 1. Hold the lower half (A) of the trimmer head with one hand. Use your opposite hand to turn the top half (B) of the trimmer head. 6. Push the trimmer line through the trimmer head and through the opposite hole. B C A D a) For straight shaft grass trimmers, turn the top half of the trimmer head clockwise. b) For curved shaft grass trimmers, turn the top half of the trimmer head counterclockwise. Note: It is not necessary to push the top half of the trimmer head down when you turn it. 7. Pull the trimmer line through the trimmer head until there is an equal length of trimmer line on each side. 8. Hold the lower half of the trimmer head stable with one hand. Use your opposite hand to turn the top half of the trimmer head. Continue to turn the top half of the trimmer head until approximately 127 mm/5 in of the trimmer line is extended from each hole. E F Note: When you turn the top half of the trimmer head, you will hear a click. 2. Continue to turn the top half of the trimmer head until the triangle (C) aligns with the hole (D). 3. Remove and discard the remaining trimmer line. 4. Cut approximately 6.7 m/22 ft of new trimmer line. 5. Put 1 end of the trimmer line into 1 of the holes. a) For straight shaft grass trimmers, turn the top half (E) of the trimmer head clockwise. b) For curved shaft grass trimmers, turn the top half (F) of the trimmer head counterclockwise. Note: If the trimmer line is too long on one side of the trimmer head, cut the trimmer line to the correct length. 1687 - 003 - 22.09.2021 17