Husqvarna P-ZT6126 Owners Manual - Page 44

maintenance Anti-scalp Rollers Anti-scalp rollers keep the deck in the proper position to help prevent scalping in most terrain conditions. Do not adjust the rollers to support the deck. Rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. IMPORTANT INFORMATION Adjust anti-scalp rollers with the mower on a flat level surface. The anti-scalp rollers can be set in three positions: • Upper position 1 to 2½" (25 to 63 mm) grass. • Middle position 2½" to 4" (63 to 102 mm) grass. • Lower position 4" to 5" (102 to 127 mm) grass. The rollers should be approximately ¼" (6.5 mm) from ground. Do not adjust the rollers to support the deck. Anti-scalp rollers IMPORTANT INFORMATION To avoid deck damage, the anti-scalp rollers must not be adjusted to support the deck. 8065-094 Caster Wheels Check every 200 hours. Check that wheels rotate freely. Removal and Installation Remove nut and caster bolt. Pull the wheel out of the fork. Install in reverse order. Tighten caster bolt. 2 Torque to 45 ft-lbs (61 Nm), then back nut off ½ turn. NOTE: Tire should rotate freely but axle spacers should not. If wheels do not rotate freely take the unit to the dealer for service. 1. Caster bolt 2. Axle spacer Caster wheel 44 1 8065-030