IBM 84903bu User Manual - Page 35
hot-swap, drives, Installing, simple-swap, drive
UPC - 000435882073
View all IBM 84903bu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
on the IBM ServeRAID Support CD for additional information about RAID operation and complete instructions for using ServeRAID Manager. 6. If you are installing additional hot-swap hard disk drives, do so now. If you have other options to install or remove, do so now; otherwise go to "Completing the installation" on page 28. IDs for hot-swap hard disk drives The hot-swap-drive backplane controls the IDs for the internal hot-swap drive bays. The following table lists the IDs for the hard disk drives and backplane that are connected to one channel in hot-swap models. In the typical configuration, the standard hard disk drives and backplane are connected to channel A. Device ID Drive bay 4 0 Drive bay 5 1 Drive bay 6 2 Drive bay 7 3 Installing a simple-swap SATA hard disk drive in bay 4, 5, 6, or 7 Some server models come with simple-swap SATA hard disk drives, which are accessible from the front of the server. Before you install a simple-swap SATA hard disk drive, read the following information: v You can install four simple-swap SATA hard disk drives in the server. v Install the drives in ascending order by bay number. Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before removing or installing a simple-swap hard disk drive. Chapter 2. Installing options 21