InSinkErator Indulge Contemporary F-GN1100 Owners Manual - Page 5

2 Installing the fauceT - 3300 a U npack dispenser components. T he recommended installation for this faucet is dispenser handle on the right. Property Damage: Do not pinch or break tubing. Do not distort the last 1 inch of tubing. The unique design allows the handle to be fully functional when placed to the right or left of faucet. Determine preferred handle placement before installing. b I nsert rubber O-ring into groove on brass seat. P  lace brass seat, O-ring side down, over hole in sink or countertop. Wetting O-ring with water prior to inserting into brass seat helps hold ring in place during installation. c To ease feeding of tubes through hole, first insert blue tube with quick-connect attachment and then insert the remaining tubes. H  olding brass seat in place, feed tubes down through the hole in sink or countertop until base touches brass seat. R  otate brass seat until the two retaining studs fit into the holes on the faucet base and base sits firmly on brass seat. d Semi-circular mounting plate should encircle all descending tubes and extend beyond sink hole when tight. F  rom under the sink, place the semi-circular mounting plate onto the threaded stud. P  lace hex nut onto the threaded stud. Ensure dispenser handle is on preferred side and that faucet head is at desired angle. I nsert screwdriver into hole on side of hex tool (creating a "T"), and use tool to tighten nut and secure faucet. 3 Mounting the tank a S  elect a spot under the sink to mount tank vertically within reach of both Tank must be plumbing and electrical connections. mounted level The tank should be within 16" or less to ensure of faucet water lines and within 30" proper operation. or less of a standard grounded outlet. ­Property Damage: Tank must be located within 16" of faucet and within 30" or less of a standard grounded outlet. DO NOT extend plumbing or electrical lines. W  hile holding tank in place on the spot selected for installation, use a pencil to mark locations for 2 hanging screws. b Leave 1/4" for hanging tank. Screws provided are for use in wood Brass Nut studs or cabinets only. Use wall anchorFserrule (not supplied) for installation into drywall. Brass In Brass Nut 1 2 Mount tank vertically in an area that allows clearance on the underside of the tank for drainage, if necessary. DO NOT over tighten screws. P re-drill 1/8" pilot holes at marks. Plastic T urn screws into pre-drilledtubheoles, leaving 1/4" exposed. H ang the tank on the screws. Plastic tube T ighten the screws with only 1/2 turn clockwise. 4 Connecting Faucet to Tank a 3 W  ithout depressing the gray button, place the snap-connect fitting at (1) (2) (3) the end of the blue or copper 1/4" tube onto the left fitting on the tank, 1 2 pushing until it clicks into place. (1) 1 2 S  lip the flexible white 7/16" tube over barbed steel fitting and slide down approximately 1/2". (2) S  lip the clear 5/16" tube over the smooth plastic fitting and slide down approximately 1/2". (3) Property Damage: Pinched or blocked water lines may cause3damage to the dispenser tank. Check to make sure tubes are connected properly and are pushed down as far as possible. C  heck for pinched or crimped tubes. Hose clamps are not needed for any of the connections. 3 8 9