InSinkErator Indulge Contemporary F-GN1100 Owners Manual - Page 9

Please read Troubleshooting Guide and/or visit www.insinkerator.com before calling AnswerLine® TROUBLESHOOTING PROBLEM Water and steam spits forcefully from spout without turning on the dispenser faucet. POSSIBLE CAUSE • Unit is boiling. May be normal during initial setup. WHAT TO DO • Activate faucet lever to release some water from the tank. • Adjust water temperature using dial on tank front. Remember that at higher altitudes, water boils at lower temperatures. Water is not hot. • The unit is unplugged. • The electric outlet is inoperative. • Make sure the unit is connected to a properly grounded electric outlet. • Make sure the circuit breaker or fuses are functioning properly. • Check that the outlet is not switched off. Water is too hot or not hot enough. • Thermostat is not adjusted to your needs. • A djust the thermostat slowly, then activate faucet lever for 20 seconds to bring in fresh water to be heated at the new setting. Allow 5-7 minutes for water to reach new temperature. Water comes out the vent instead of spout. • Outlet tube is blocked. • Check that outlet tube is not kinked, twisted or pinched. • Unscrew spout end piece and clean out any debris. Water is dripping from the spout/vent intermittently. • The expansion chamber isn't draining • Unplug the unit. If the dripping doesn't stop after a few properly due to low water pressure. minutes, check the supply valve to ensure that is fully • The spout is blocked. open and there are no obstructions in the water line reducing the pressure below 30 psi (i.e., a poorly mounted saddle valve, a clogged water filter, or a partially opened shut-off valve). • Unscrew spout end piece and clean out any debris. Water is dripping • Debris in the water line may be from the spout/vent con- in the faucet valve seat causing a stantly. slow water leak. • Unscrew spout end piece and clean out any debris. • Activate faucet lever 7-10 times to flush faucet & lines. Divided stream. • Debris in the end piece. • Unscrew spout end piece and clean out any debris. Water discoloration/rusty • Corrosion of unit. appearance. • Unplug and drain unit as described in the Seasonal Storage/Drainage Section on page 14 of this manual. If the water discoloration remains after draining and refilling unit, discontinue use and contact an authorized InSinkErator service agent. FILTRATION ISSUES Water taste or odor. • Filter needs to be flushed out. • Life of filter has expired. • A ctivate the faucet lever and run until the water is cold. If there is no change, replace filter cartridge. New filter leaks or doesn't fit. • Head and bracket not fully rotated. • Remove, inspect, reinstall filter cartridge. • Filter O-ring breach. • Remove new filter, replace with old filter. Check operation. If OK, reinstall new filter and recheck operation. No water flow or low water flow. • Life of filter has expired. • Replace filter cartridge. See page 14. If you are still experiencing trouble call the AnswerLine® 1-800-558-5700. 16 Dispensador de agua caliente instantánea Manual del usuario CONTEMPORARY ANTIQUE TUSCAN MODERN SST-FLTR Instalación, cuidado y uso Installation, Care & Use Installation, soin et utilisation GN/HC1100 GN/HC2200 GN/HC2215 H/HC3300