JVC FS-B70 Instruction Manual - Page 48
Setting the Clock, To show the clock when the unit is turned on, To change the clock
View all JVC FS-B70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
English Basic and Common Operations Setting the Clock Before operating the unit any further, first set the unit's clock. When you plug in the power cord, "AM 12:00" starts flashing on the display. You can set the clock when the unit is either turned on or in standby mode. On the remote control ONLY: 1 Press CLOCK/TIMER. CLOCK/ TIMER The hour digits start flashing on the display. 2 Press UP or DOWN to adjust UP the hour, then press CLOCK/ TIMER. DOWN The minute digits start flashing. • When you press and hold UP or DOWN, the hour digit changes continuously. CLOCK/ TIMER 3 Press UP or DOWN to adjust the minute, then press CLOCK/TIMER. The built-in clock starts. To change the clock 1 Make sure the (timer) indicator and the timer mode indicator (DAILY or REC) are not lit on the display. • If they are lit, press and hold CLOCK/TIMER until they go off. 2 Press CLOCK/TIMER repeatedly until the unit enters the clock setting mode (the hour digits start flashing on the display). First time you press CLOCK/TIMER, the unit enters the timer setting mode. (See page 25.) 3 Repeat steps 2 and 3 of the procedure "Setting the Clock." 4 Press and hold CLOCK/TIMER again so that the (timer) indicator and the timer mode indicator (DAILY or REC) go off. To turn off the clock indication (power save mode) On the remote control ONLY: Press DISPLAY while the unit is in standby mode. "DISPLAY OFF" appears on the display and the clock indication goes off. DISPLAY To turn on the clock indication, press DISPLAY again while the unit is in standby mode. "DISPLAY ON" appears on the display. • When you unplug the power cord or if a power failure occurs The clock is reset to "AM 12:00" right away. If this happens, set the clock again. • The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock. To show the clock when the unit is turned on On the remote control ONLY: Press DISPLAY. The clock indication appears on the display. DISPLAY To return to the normal display, press DISPLAY again. 9