JVC GZ-HM960BUS Bluetooth Application Software for Smartphones - Page 12

When using Blackberry, When using Touch Pro/Touch Diamond

Get JVC GZ-HM960BUS PDF manuals and user guides View all JVC GZ-HM960BUS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Preparing the Camera for Bluetooth connection When using Blackberry Configure the setting below to use the GPS function. 11 Press the menu key and select [Options] - [Advanced Options] - [GPS]. 22 Set [GPS Data Source] to [Device GPS]. 33 Set [GPS Service] to [Location ON]. 44 Press the menu key and select [Save]. When using Touch Pro/Touch Diamond Register the camcorder after pairing following the steps below. * If you use HD2, the following operation is not required. 11 Select [Start] - [Settings]. 22 Open [Connection] and select [Bluetooth]. 33 Open [Devices] and select a camcorder to connect to. 44 Tick the [Serial port] checkbox and tap [Save]. 55 Open the [COM Ports] tab and select [New Outgoing Port]. 66 Select a camcorder to connect to and tap [Next]. 77 Select the [COM 0] port. 88 Remove the tick in the [Secure Connection] checkbox and tap [Finish]. If [COM 0] is already in use, select the port which has the next youngest number. If you cannot register, select the next port and try again. 99 Tap [OK] on the upper right to close the setting screen. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Preparing the Camera for Bluetooth connection
11
When using Blackberry
Configure the setting below to use the GPS function.
Press the menu key and select [Options] - [Advanced
1
Options] - [GPS].
Set [GPS Data Source] to [Device GPS].
2
Set [GPS Service] to [Location ON].
3
Press the menu key and select [Save].
4
When using Touch Pro/Touch Diamond
Register the camcorder after pairing following the steps below.
* If you use HD2, the following operation is not required.
Select [Start] - [Settings].
1
Open [Connection] and select [Bluetooth].
2
Open [Devices] and select a camcorder to connect to.
3
Tick the [Serial port] checkbox and tap [Save].
4
Open the [COM Ports] tab and select [New Outgoing Port].
5
Select a camcorder to connect to and tap [Next].
6
Select the [COM 0] port.
7
Remove the tick in the [Secure Connection] checkbox and
8
tap [Finish].
If [COM 0] is already in use, select the port which has the next
youngest number. If you cannot register, select the next port and try
again.
Tap [OK] on the upper right to close the setting screen.
9