JVC L20U DLA-L20U User instruction manual (2.6MB) - Page 54

Operating the Main Menu (Cont.) Setting Up Channels (Cont.) s Remote control unit OPERATE COMPUTER VIDEO MENU/ENTER button VOL. PAGE BACK T ZOOM W FOCUS MENU/ENTER PRESET QUICK ALIGN. Cursor buttons AV MUTING s To set up a switcher number "SWNo" : 1 Press the cursor button 3 to move to "SWNo". • The selected item is shown in magenta color on the screen. • If any "LINE" item is not selected, you cannot choose a "SOURCE" or "SWNo" item. First, register a "LINE" item. 2 Press the MENU/ENTER button to set (fix). • The SWITCHER number setup menu is displayed on the screen. SWITCHER S W I T C H E R NO. 1 (Switcher Number Setup menu) PAGE BACK button sCHANNEL setup menu CHANNEL (AUTO) CH LINE SOURCE SWNo 1 Y/C NTSC(480i) 1 2 VIDEO PAL/SECAM 2 3 77777 777777777 77 4 77777 777777777 77 5 77777 777777777 77 6 77777 777777777 77 7 77777 777777777 77 8 77777 777777777 77 9 77777 777777777 77 10 77777 777777777 77 3 Press the cursor button 2 or 3 to select a number. • Numbers that you can choose from are numbers from 1 to 20 and symbols "77" that signify non-registration. • Pressing the cursor 2 makes the number smaller. Pressing the cursor 3 makes the number larger. • If you select "77", any "SWNo" item is not registered. • If a channel is selected, you cannot make any settings or changes. 4 Press the PAGE BACK button. • When you press PAGE BACK, the switcher number is set, and the display returns to the "CHANNEL setup" menu. • Be careful that if you set the same switcher number to a few channels and operate using the switcher number, the youngestnumber channel is switched to because channels are read in the order of channel numbers. Notes • The selected item is shown in magenta color. Items shown in gray color cannot be operated or set in the current mode. • Items that can be set are different when video signals are input and when computer signals are input. • For dedicated source signals (corresponding frequency, etc.) for computer signals, see page 19. Note • You can automatically switch the channels of the projector by specifying a switcher number through an external controller. As an example, if switcher number 1 (SWNo 1) has been registered to channel number 1 (CH1), specifying switcher number 1 (SWNo 1) automatically switches the projector to channel number 1 (CH1). (For this operation, a setup is required to communicate between the projector and the external controller.) For information on external controllers, contact the dealer where you purchased your projector. ENGLISH 53