JVC TK-C215V4U Instructions - Page 10

Introduction Setting the Lens and Switches Set the video setting switches on the camera unit before mounting it. To set the switches, use a fine-tipped screwdriver. A B C D E RESET/[SPOT] B R LL PHASE 1 2 3 4 5 6 7 8 O N2 4 WHT. BAL. L H IRIS LEVEL FOCUS ADJUST F G Function selection switch setting table (Items in bold are factory position) OFF ON 1 AGC OFF ON 2 SELECT PHASE WHT.BAL. 3 SYNC LL INT 4 WHT.BAL. ATW MANU 5 BLC OFF ON 6 DAY/NIGHT OFF ON 7 RESERVED SET TO OFF 8 RESET/SPOT RESET SPOT A [RESET/SPOT] RESET/SPOT button When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value. ● When the 2 [SELECT] switch is set to WHT.BAL., the white balance is reset to the default value. When the switch is set to PHASE, the phase is reset to the default value. ● When setting to SPOT: When this button is pressed, white spots are corrected. For instructions on correcting white spots, see AWhite-spot correctionB (A pg. 21). B [R/B, +/-] R/B, +/- adjustment button This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock. The function of this button is selected using the 2 [SELECT] switch. ● When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint. Press the B button to increase the blue tint and decrease the red tint. ● When adjusting the phase: Press the + or - button to adjust the phase. C Function selection switches 1. [AGC] Auto-gain control switch. Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON) 2. [SELECT] WHT.BAL./PHASE setting switch. WHT.BAL.: The B [R/B, +/-] buttons are used as [R/B] adjustment buttons. PHASE: The B [R/B, +/-] buttons are used as [+/-] adjustment buttons. (Default setting: WHT.BAL.) 3. [SYNC] Synchronization system selection switch. This switch sets the synchronizing system for the camera. INT: This is set for internal synchronization LL (Line Lock): The camera's vertical synchronization is locked to the AC 24 V 60 Hz power line frequency. When switching between multiple cameras using a switcher, selecting this mode and adjusting the vertical phase can reduce the monitor sync disturbances occur that when the camera image is switched. (Default setting: INT) 10