JVC TK-C215V4U Instructions - Page 9
Camera (Interior), Fall Prevention Wire Supplied and Wire
UPC - 046838023170
View all JVC TK-C215V4U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Camera (Interior) The dome cover, inner dome and outer case are removed. Procedures for removal. (A pg. 14 AEmbedding the camera to the ceilingB, Step 3. to Step 5.) V Lens (A Next page) J U Camera Unit (Rear) W T S O R Q K L P O M N J Strap A plate to connect the camera unit and the dome cover. K Fastening Screw (x 3) When embedding the camera in the ceiling, turn this screw to secure the camera. This screw belongs to a part of the ceiling mount bracket P. L [MONITOR] terminal (RCA pin) (A pg. 19) M Camera Unit N Fall Prevention Wire Fastening Hook O Fall Prevention Wire (Supplied) and Wire Mounting Screw These are the wires and screws connecting the camera unit M and the outer case C. One end of the wire is connected to the hook N securing the safety wire. P Ceiling Mount Bracket (x 3) This is used as a bracket when embedding the camera to the ceiling. (A pg. 14) Q Camera Fastening Screw Use this to fasten the camera unit M to the outer case C. To remove (A pg. 14, 16). R Pan fastening Screw Ensure to loosen the screw before setting. Further tighten the screw to ensure that camera's shooting direction does not go out of alignment only when it is used in a location with strong vibration. (A pg. 20) S Imaging Direction mark Install the camera by aligning the imaging direction with the arrow mark. T Rotation Knob Rotate the lens unit to adjust the inclination of the image (to be turned). U Rotation Center Mark (A pg. 20) V Tilt Lock screw Tighten the screw to ensure that camera's shooting direction does not go out of alignment when it is used in a location with strong vibration. (A pg. 20) W Fall Prevention Wire mounting hole & Screw (Fall Prevention Wire not included.) 9