JVC TK-C215V4U Instructions - Page 21

Mounting the Inner Dome After setting is complete, mount the Inner dome. Claws (3 locations) White-spot correction As a general characteristic unique to CCDs, white-spots may appear on the screen with age. In order to reduce this phenomenon, this unit is equipped with a white-spot correction feature. Switch on the camera power supply and wait for at least 30 minutes. Inner Dome RESET/[SPOT] [SPOT] button B R 1. Mount the inner dome . Mount the inner dome to the claws (3 locations). CAUTION: ● Mount the inner dome such that it does not cover the lens. ● When mounting the inner dome, be careful not to move the lens position. The image angle set previously will go out of alignment. Mounting the Dome Cover After setting is complete, mount the dome cover. Position mark 1. 1. Mount the dome cover. Align the position marks on the camera unit and dome cover, followed by pressing in directly to mount the cover. CAUTION: Press the dome over until a "click" sound is heard. Check that the cover is firmly mounted. Failure to mount the cover firmly may cause this cover to fall off. LL PHASE 1 2 3 4 5 6 7 8 O N2 4 WHT. BAL. Function selection switch 8 1. Remove the dome cover. 2. Cover the lens surface using a black sheet of paper, etc. so that light does not enter the lens. 3. Set the function selection switch 8 to [SPOT]. (A pg. 11) 4. Press and hold the SPOT CORRECTION button for more than 2 seconds. ● White-spot correction will start. Correction may take several seconds for completion. NOTE: ● Maximum correction: 32 ● The white-spot correction feature of this unit does not guarantee the correction of all white spots. Depending on the characteristic of white spots, correction may not be possible. ● When performing white-spot correction, accurate data may not be achieved in case of highly detailed pixels since correction is made using the information of surrounding pixels. ● The result of white-spot correction is maintained until the next correction is performed. 21