Jensen PCD120U Owners Manual - Page 5
Wiring
View all Jensen PCD120U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
PCD120U WIRING Antenna Connector WARNING! Never combine (bridge) outputs for use with 1 speaker. WARNING! Never ground negative speaker leads to chassis ground. CAUTION: Failure to wire exactly as shown may cause electrical damage to the radio. Gray Blue Black Yellow 15A + Red 0.5A LF/AVG White/Black (-) LR/ARG White (+) Green/Black (-) Green (+) 5 Gray/Black (-) Gray (+) Violet/Black (-) Violet (+) RF/AVD RR/ARD Amplifier Wiring Connect line out for optional external amplifiers. The red connector is for the right and the white connector is for the left. Power Antenna Connect to power antenna or amplifier. If not used, tape bare end of wire. Ground Connect to ground terminal. Memory/Battery Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected. Accessory/Ignition Connect to existing radio wire or radio fuse. Fuses When replacing a fuse, make sure the new fuse is the correct type (AGC) and amperage. Using an incorrect fuse could damage the radio.