Kenmore 3243 Installation Instructions - Page 8
Electrical, Requirements, Grounding, instructions, Check, Operation - installation guide
View all Kenmore 3243 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Electrical Requirements 120 volt, 60 Hertz, properly grounded branch circuit protected by a I 5 amp circuit breaker or time delay fuse. Do not use an extension cord with this cooktop. Grounding instructions IMPORTANT Please read carefully. For persona[ safety, this appliance must be properly grounded. The power cord of this appliance is equipped with a 3prong (grounding) plug which mates with a standard 3prong grounding wall receptacle (see Figure 7) to minimize the possibility of electric, shock hazard from the appliance. The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. Preferred Method Grounding type wall receptacle not, under any circumstances, cut, remove, or bypass the grounding prong. Check Operation Refer to the Use and Care Guide packaged with the cooktop for operating instructions and for care and cleaning of your cooktop. Do not touch the burners. They may be hot enough to cause burns. . Instal[ Burner Caps This cooktop is equipped with sealed burners as shown (see Figure 8). A. Unpack your burner heads and burner caps. B. Place burner head over each gas orifice, matching the head with the orifice size. Be careful not to damage the electrode while placing the head over the orifice. Make sure electrode fits correctly into slot in burner head. C. Place a burner cap on each burner head, matching the cap size to tile head size. Each burner cap has an inner locating ring which centers the cap correctly on the burner head. D. Be sure that all the burner caps and burner heads are correctly placed BEFOREusing your cooktop. Burner Ca[ Power supply cord with 3prong grounding plug. Figure 7 Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly' grounded 3prong wall receptacle. Do not, under any drcumstances, cut or remove the third (ground) prong from the power cord. Disconnect electrical supply cord from wall receptacle before servicing cooktop. Burner Head Figure 8 NOTE: There are no burner adjustments necessary on this cooktop.