Kenwood KDC-BT952HD Instruction Manual - Page 42
Connecting Wires to Terminals, Installing/Removing the unit - wiring
View all Kenwood KDC-BT952HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Connecting Wires to Terminals To USB device USB connector (0.8 m (2.7 ft)) Microphone (Accessory5) Microphone input Fuse (10A) Wiring harness (Accessory1) ⁄ Do not remove the cap when you do not use the USB cable. The connector will cause the unit to malfunction if it gets in touch with any metallic part of the vehicle. Rear output R L Front output Sub Woofer output Antenna Cord RL FM/AM antenna input AUX input (Stereo) Use the mini-plug which is stereo type and does not have any resistance. (3.5 mm (1/8") ø) To SiriusXM Connect Vehicle Tuner (optional accessory) White White/Black Gray Gray/Black Green Green/Black Purple Purple/Black To front left speaker To front right speaker To rear left speaker To rear right speaker If no connections are made, do not let the wire come out from the tab. Blue/White (Power control wire) Blue (Antenna control wire) Brown (Mute control wire) P.CONT ANT. CONT MUTE When using the optional power amplifier, connect this wire to its power control terminal. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type or short pole type antenna. (Max. 300mA, 12V) To connect the Kenwood navigation system, consult your navigation manual. Orange / White (Dimmer control wire) ILLUMI Light Blue/Yellow (Steering remote control wire) REMOTE CONT STEERING WHEEL REMOTE INPUT Car fuse box Red (Ignition wire) ACC Yellow (Battery wire) Black (Ground wire) · (To car chassis) To car light control switch To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matches your car is required. Ignition key switch Car fuse box (Main fuse) 83 | KDC-X996/ KDC-BT952HD + - Battery Installing/Removing the unit non-Japanese cars Removing the hard rubber frame 1 Engage the catch pins on the removal tool and release the two locks on the upper part of frame. Lift up and pull the frame forward as shown in the figure. Bend the tabs of the mounting sleeve with a screwdriver or the like and attach it in place. ⁄ • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). Japanese cars 1 Remove the hard rubber frame with reference to . 2 Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws. T N T/N NT T: Toyota cars N: Nissan cars Lock Catch Accessory2 Removal tool 2 When the upper part of frame is removed, remove the lower part of frame. ⁄ • The frame can be removed from the bottom side in the same manner. Removing the Unit 1 Remove the hard rubber frame with reference to . 2 Detach the faceplate. 3 Insert the two removal tools deeply into the slots on both sides as shown. 4 Lower the removal tool toward the bottom, and then pull out the unit halfway while pressing the removal tool towards the inside. Accessory2 3 ø5mm 8 mm MAX. 4 ø5mm Accessory3...for Nissan car Accessory4...for Toyota car 8mm MAX. ¤ CAUTION Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot. ¤ • Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, being careful not to drop it. English | 84