Kenwood TH-D75 User Manual - Page 24
Activating the Tone Function, Selecting a Tone Frequency, Tone Frequency ID, Frequency
View all Kenwood TH-D75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Activating the Tone Function To turn the Tone function on: 1 Select your desired band A or B. 2 Press [TONE] to turn the Tone function On. • Each time you press [TONE], the selection changes as follows: Tone ( Tone ( ) CTCSS ( ) DCS ( : default) Off (no display). ) Cross Additionally, when APRS is ON and Voice Alert is configured, Voice Alert ON is added to the above cycle. • The < > icon appears on the display when the tone function is On. Selecting a Tone Frequency To select the tone frequency required to access your desired repeater: 1 Turn the Tone function On. 2 Press [F], [TONE]. • The current Tone frequency appears on the display and blinks. The default frequency is 88.5 Hz. 3 Select your desired frequency. 4 Press [ENT] to set the selected frequency. Note: ¡ If you have set up a Memory channel with a tone setting, simply recall the Memory channel instead of setting up the tone frequency every time. No. Frequency (Hz) No. Frequency (Hz) No. Frequency (Hz) 01 67.0 18 118.8 35 183.5 02 69.3 19 123.0 36 186.2 03 71.9 20 127.3 37 189.9 04 74.4 21 131.8 38 192.8 05 77.0 22 136.5 39 196.6 06 79.7 23 141.3 40 199.5 07 82.5 24 146.2 41 203.5 08 85.4 25 151.4 42 206.5 09 88.5 26 156.7 43 210.7 10 91.5 27 159.8 44 218.1 11 94.8 28 162.2 45 225.7 12 97.4 29 165.5 46 229.1 13 100.0 30 167.9 47 233.6 14 103.5 31 171.3 48 241.8 15 107.2 32 173.8 49 250.3 16 110.9 33 177.3 50 254.1 17 114.8 34 179.9 Tone Frequency ID This function scans through all tone frequencies to identify the incoming tone frequency on a received signal. You can use this function to find which tone frequency is required by your local repeater. 1 Press [TONE] to turn the Tone function On. • The < > icon appears on the display. 2 Press [F], press and hold [TONE] to run the Tone Frequency ID scan. • Scan starts and "Scanning" blinks on the display. • To quit the scan, press [ ]. • When a Tone frequency is identified, the identified frequency appears on the display and blinks. 3 Press [A/B] to program the identified frequency in place of the currently set tone frequency. 7-2