KitchenAid KBNU487VSS Use & Care Guide - Page 15

4. Install the tank tray mounting brackets to the base or floor of the island using the proper size and type of mounting hardware (not supplied). Tighten mounting hardware. A B C 7. The tank tray for the 20 lb LP gas fuel tank must be adjusted so that the bottom of the tank tray is ¹⁄₈" (0.32 cm) above the cabinet door opening and is level. The top nut on each of the mounting brackets is to be loose. Turn the bottom nuts counterclockwise to raise the tank tray and turn the bottom nuts clockwise to lower the tank tray. When the tank tray is level and slides in and out without touching the cabinet door opening at the bottom or top with the 20 lb LP tank installed, tighten the top nuts against the adjustment flange. 3" (7.6 cm) A. Screw (Use proper screw for island floor material.) B. Lock washer C. Flat washer 5. Pre-adjust each of the bottom nuts on the mounting brackets to 3" (7.6 cm) from the base of the island to the top of the nuts. 6. Remount the tank tray back onto the mounting brackets. Replace the 4 top nuts, but do not tighten. A B A B A. Top nut loosened B. Top nut tightened NOTE: A bracket or shelf (not supplied) that is large enough to keep a second 20 lb LP gas fuel tank from being stored in the storage area under the grill is required to be mounted inside the island. Bracket dimensions are shown for reference. C D A. 20 lb LP gas fuel tank B. Tank tray for 20 lb gas fuel tank C. Top nut (do not tighten) D. Mounting bracket 11 30 cm) 6" (15.2 cm) 21" (53.3 cm) for 48" (121.9 cm) doors 9" (22.9 cm) for 36" (91.4 cm) doors 2⁵⁄₆" (6.8 cm) 8. Plug in the electrical connector from the back of the grill to the electrical connector from the 20 lb LP gas fuel tank tray. A B A. Electrical connector from 20 lb LP gas fuel tank tray B. Electrical connector from back of grill NOTE: These connectors must be plugged in for the electronic control "Fuel Remaining" feature to work for use with a 20 lb LP gas fuel tank. 15