Konica Minolta bizhub 283 bizhub 423/363/283/223 Enlarge Display Operations Us - Page 32
Basic], Finisher FS-527, Finisher FS-529, Job Separator JS-505, Settings
View all Konica Minolta bizhub 283 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
3.2 [Basic] Settings [Offset] 3 Specify whether to separate each set of copies from another set in the output tray when copying multiple sets of multi-page originals. • If Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is not installed: If the following conditions are met, printed copies are fed out and sorted in an alternating crisscross pattern. 8-1/2 e 11 or A4 or B5-size paper is used. Paper of the same size and type is loaded in the w direction and v direction. The auto paper setting is selected in the paper/size function. • If Finisher FS-527, Finisher FS-529 or Job Separator JS-505 is installed: The copies are fed out and stacked on top of each other with each set staggered to separate them. [Staple/Punch] [Staple]: Copies can be bound with a staple in the corner or with two staples. bizhub 423/363/283/223 [Punch]: Copies can be fed out hole-punched. The number of punched holes varies depending on the country you are in. 1 [Position Setting] Select the desired staple or hole-punch position. • [Auto]: The staple or hole-punch position is automatically set either at the top or at the left. A staple or punch position along the long side of the paper is selected if the original length is 11-11/16 inches (297 mm) or less. A staple or punch position along the short side of the paper is selected if the original length exceeds 11-11/16 inches (297 mm). • If [Auto] is selected for the staple or holepunch position, load the original with the top toward the back of the machine. • If desired, press [Original Direction], and then select the original direction. 3-11