Konica Minolta bizhub C552 LK-101/LK-102/LK-103/LK-105 License Authentication - Page 51
Repair
View all Konica Minolta bizhub C552 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
for Customer Engineer Repair After replacement of the parts, the message "License Management Error occurred" may be displayed on the control panel. When the message appears, it is necessary to perform repair operation. ¾ The repair operation can be done with accessing LMS. When those parts as listed below are replaced, the message "License Management Error" may be displayed. ¾ When replacing those parts below, please replace it with new parts. When the parts are replaced with used parts, the message condition can not be solved by performing the repair operation. NVRAM Service EEPROM Board ¾ If License Activation Base function was already activated z While the error message is indicated on the control panel, the License Activation Base Function will not be disabled. z When the error message is indicated after replacement of the NVRAM, License Activation is required after the completion of the repair operation to use the function again. ¾ If License Activation Base function was not activated z Even the function was not activated, the message may be indicated if those parts mentioned before is replaced. MFP can be used without the repair operation, but to solve it, the repair operation is required. Issued by BT-CSO 51 Ver 1.01