Konica Minolta bizhub C552 LK-101/LK-102/LK-103/LK-105 License Authentication - Page 66

for Customer Engineer Initialization Procedure The following is the step by step procedure for initialization. 1. Gather necessary information 1-1. Get [Request Code], [Serial Number] and [Service History] from MFP. 2. Prepare Initialization 2-1. Contact the Support Contact. 2-2. Get [Initialization Code] from Support Contact. 3. Perform Initialization 3-1. Input [Initialization Code] to MFP and perform Initialization. After performing Initialization, License Activation Base Function will be disabled. Please refer to [Activation Procedure] and activate the License Activation Base Functions again. When using each code, please pay attention "U" and "V", "0(number)" and "O(alphabet)". "0 (Number)" is not used in [Request Code] and [Initialization Code]. Here are necessary information (operation) and acquisition procedure in the above steps. Information (operation) Acquisition Procedure Note Request Code a) MFP panel 30 digits alphanumeric - Administrator Mode Inform your Support - Service Mode Contact. b) PSWC (Administrator Mode) Serial Number Displayed on the same screen as 13 digits alphanumeric Request Code. EG.)A00H020012345 Serial Number Label Contact Support contact. [Service History] Contact Support contact. -Parts replacement -Result of Repair operation etc.. Initialization Code Customer engineer gets the code 35 digits alphanumeric from Support contact. Initialization Input to MFP panel. (Input Initialization Code) Service Mode Issued by BT-CSO 66 Ver 1.01