Konica Minolta bizhub PRESS C71hc bizhub PRESS C1060/C1070/C1070P/PRO C1060L D - Page 14
Contents of both sides adjustment items
View all Konica Minolta bizhub PRESS C71hc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Contents of both sides adjustment items This section describes the contents of the following four adjustment items. - Fine adjustment of the paper feed tray side guide (PF-707/PF-602m) (Page 2-3) - Front side adjustment (Page 2-6) - Gap adjustment (Back side adjustment) (Page 2-12) - Back side fine adjustment (Page 2-18) )Fine adjustment of the paper feed tray side guide (PF-707/PF-602m) 1 Pull out the tray to load paper into. NOTICE Trays can be pulled out only when this machine is turned on. Before pulling out the target tray, check that the sub power switch is turned on. 2 Turn the side guide lock knobs (2 pieces) counterclockwise to loosen them. PF-602m has 4 side guide lock knobs. 3 Widen the side guide plates on both sides with pressing the side guide lock release lever ( ). NOTICE To slide the side guide plates, be sure to hold both side guide plates together. If you move it by holding only either of the side guide plate, the side guide plate that is held may become displaced. 4 Widen the rear guide plates on both sides with pressing the rear guide lock release lever. 5 Load an appropriate amount of paper into the tray while aligning it to the left-hand side of the tray. NOTICE Load paper with the print side facing up. 2-3