Konica Minolta bizhub PRESS C71hc bizhub PRESS C1060/C1070/C1070P/PRO C1060L D - Page 20
press [Adjustment Start].
View all Konica Minolta bizhub PRESS C71hc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
11 Check the length of [2], [4], [6], and [8] of the charts that are output as the second and third sheet. Write down the measured lengths so that you do not forget them. [5] [1] When the length of [2], [4], [6], and [8] is within the following range, press [Close] and go to step 15. When the length of [2], [4], [6], and [8] is out of the following range, measure [1], [3], [5], and [7], and go to the next step. [5] [7] [1] [2] [2]: 200mm±0.3mm [4]: 200mm±0.3mm [6]: 200mm±0.3mm [8]: 200mm±0.3mm [6] [8] [3] [4] 12 Press each point number, then enter the measured length using the keypad on the screen. To reset a value, press [Clear]. 13 When entry processing is completed, press [Adjustment Start]. 2-9
2-9
11
Check the length of [2], [4], [6], and [8] of
the charts that are output as the second
and third sheet.
Write down the measured lengths so that you do
not forget them.
When the length of [2], [4], [6], and [8] is within the
following range, press [Close] and go to step 15.
When the length of [2], [4], [6], and [8] is out of the
following range, measure [1], [3], [5], and [7], and
go to the next step.
[2]: 200mm±0.3mm
[4]: 200mm±0.3mm
[6]: 200mm±0.3mm
[8]: 200mm±0.3mm
12
Press each point number, then enter the
measured length using the keypad on the
screen.
To reset a value, press [Clear].
13
When entry processing is completed,
press [Adjustment Start].
[1]
[5]
[7]
[6]
[8]
[2]
[3]
[4]
[1]
[5]