Konica Minolta bizhub PRESS C71hc bizhub PRESS C1060/C1070/C1070P/PRO C1060L D - Page 32
Output about 3 sheets of the same job data that you output in step 1 from the same
View all Konica Minolta bizhub PRESS C71hc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
13 Check the position difference of the back side among the back side images of the + second and third output that were output after the magnification adjustment is completed. The black line in the figure shows the back side, - + and the blue dashed line shows the other side (front side). When the position of the front side image and the back side image differs, input the adjustment - value in [Up/Down] (crosswise direction) and [Right/Left] (paper feed direction). To move the image up or to the right, enter the value with a positive mark (+). To move the image back down or to the left, enter the value with a negative mark (-). Example of adjusting the image position: When the back side is misaligned to the front side by 0.5 mm down and 0.3 mm to the right, enter [+0.5 mm] in [Up/Down], and [-0.3 mm] in [Right/Left]. Tips - The adjustment value changes 0.1 mm on a 1-step basis. - Adjustment range: [Up/Down] -10.0 to +10.0, [Right/Left] -3.0 to +3.0 14 After the adjustment is completed, press [OK]. 15 Output about 3 sheets of the same job data that you output in step 1 from the same tray. 16 Check the image position difference of the back side of the jobs that are output as the second and third sheet. Repeat from step 13 to step 15 until all image position difference are cleared. When all image position difference are cleared, exit the adjustment. 2-21