Konica Minolta fi-7180 fi-5900C Operations Guide - Page 205
Thin Paper Mode
View all Konica Minolta fi-7180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
8.9 Thin Paper Mode If nonstandard thin paper cannot be fed and scanned smoothly, use this mode. In this mode, sheets of paper are fed at a slower speed so that thin paper can be fed and scanned properly. Follow the steps below to switch to the Thin Mode. 1. Start up the Software Operation Panel. Refer to "8.1 Scanner Settings" on page 166. 2. Select the "Thin Paper Mode" setting on the [Device Setting 2] tab. 8 SCANNER SETTINGS 3. To switch to Thin Paper Mode, select "Enable". ATTENTION In Thin Paper Mode, the document is scanned at a lower speed, and thus it takes longer. This mode should be used only for thin paper. Set the setting to "No" while you use paper of standard thickness. About the paper thickness, refer to "7.2 Document Quality" on page 153. 8.9 Thin Paper Mode 185