Kyocera FS-9500DN FS-9100/9500 Operation Guide Rev-1.3 - Page 99
Port Settings, C:\>MODE COM1:96, N
UPC - 632983001073
View all Kyocera FS-9500DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Appendix C Host Computer Interface 5 The Properties sheet is displayed for the selected COM port. Click on the Port Settings tab and set the port properties. 6 After setting the properties, click the OK button. Q DOS 1 Enter the following commands: C:\>MODE COM1:96,N,8,1,P C:\>MODE LPT1:=COM1 2 To test the interface, enter the following: CTRL P C:\>DIR CTRL P The software settings made using the above procedures are temporary. On most computers, permanent settings must be made with DIP switches. If you want to use a different baud rate or change any of the other RS-232C parameters, this can be accomplished from the printer's operator panel. See Changing the Interface Parameters on page 3-18. C-5
Appendix C
Host Computer Interface
C-5
The Properties sheet is displayed for the selected
COM
port. Click on the
Port Settings
tab and set the
port properties.
After setting the properties, click the
OK
button.
Q
DOS
Enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are
temporary. On most computers, permanent settings must be
made with DIP switches.
If you want to use a different baud rate or change any of the other
RS-232C parameters, this can be accomplished from the print-
er’s operator panel. See
Changing the Interface Parameters on
page 3-18
.
5
6
1
2