Kyocera TASKalfa 6501i 6501i/8001i Operation Guide - Page 183

Operation on the Machine > Loading Originals Loading Originals in the Document Processor The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are scanned. Originals Supported by the Document Processor The document processor supports the following types of originals. Detail Weight Document Processor 35 to 220 g/m2 (duplex: 50 to 220 g/m2) Sizes smaller than B6-R are 50 to 105 g/m2 (one-side/duplex) Sizes No. of sheets Maximum A3 to Minimum A6-R Maximum Ledger to Minimum Statement-R Plain paper (80 g/m2), Colored paper, Recycled paper, High Quality: 175 sheets (Mixed size originals: 30 sheets) Thick paper (157 g/m2): 89 sheets Thick paper (120 g/m2): 116 sheets Art paper: 1 sheet Originals Not Supported by the Document Processor Do not use the document processor for the following types of originals. • Soft originals such as vinyl sheets • Transparencies such as OHP film • Carbon paper • Originals with very slippery surfaces • Originals with adhesive tape or glue • Wet originals • Originals with correction fluid which is not dried • Irregularly shaped (non-rectangular) originals • Originals with cut-out sections • Crumpled paper • Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.) • Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the originals to jam.) How to Load Originals IMPORTANT • Before loading originals, be sure that there are no originals left on the original eject table. Originals left on the original eject table may cause the new originals to jam. • Do not make an impact on the document processor top cover, such as aligning the originals on the top cover. It may cause an error in the document processor. 5-3