Kyocera TASKalfa 6501i 6501i/8001i Operation Guide - Page 457

Troubleshooting > Troubleshooting Symptom 2 or more sheets are ― overlaps when ejected. (multi feed) Checkpoints Corrective Actions Load the paper correctly. Reference Page page 3-18 page 3-26 Printouts are wrinkled. Printouts are curled. Cannot print. Cannot print with USB memory. USB memory not recognized. Printouts have vertical lines. Are the originals loaded correctly? ― ― Is the paper damp? ― Is the paper damp? Is the paper printed out to the 4,000Sheet Finisher? Is the machine plugged in? Is the machine powered on? Are the printer cable and network cable connected? Was the machine powered on before the printer cable was connected? Is the print job paused? Is the USB host blocked? ― Are the slit glass and the Dual scanning area dirty? Load the paper correctly. Clean the paper separator. Turn the orientation 180 degrees around in which the paper is positioned. Replace the paper with new paper. Turn the paper over in the cassette, or turn the orientation 180 degrees around in which the paper is positioned. Replace the paper with new paper. Change the [Correct Paper Curl]. Plug the power cord into an AC outlet. Turn on the main power switch. Connect the correct printer cable and network cable securely. Power on the machine after connecting the printer cable. Resume printing. Select [Unblock] in the USB host settings. Check that the USB memory is securely plugged into the machine. Clean the slit glass and the Dual scanning area. page 3-18 page 3-26 page 10-5 page xiv page 3-18 page 3-26 page 3-16 page xiv page 3-18 page 3-26 page 3-16 page 8-59 ― page 2-12 page 2-6 ― page 7-4 page 8-50 ― page 10-3 10-17