LG DLG5988S Owners Manual - Page 7
electrical connections - reviews
View all LG DLG5988S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
;;;ii!iiiiiiiiiiiiiiiiiiiiiiiii The following instructions will help guide you through the initial steps of setting up your dryer for use. Please note that every section of this manual provides important information regarding the preparation and use of your dryer, and it is important that you review this entire manual before proceeding with any installation or use. More detailed instructions concerning electrical connections, gas connections, and exhaust requirements are provided at other parts of this manual. Choose a location with a solid floor for your dryer. Place the dryer at least eighteen inches above the floor for a garage installation. After placing the dryer in the desired location, please make sure that it has the required clearances shown below, and sections on Exhaust and Maintenance requirements. If you are installing your dryer in a manufactured or mobile home, please refer to STEP 9 below for additional instructions. 38.7" (98.3 cm) # / 49.8" (126.4 cm) Certain minimum clearances are required above, behind, and to the sides of the unit, as shown below. Those required minimum clearances are set forth in the picture below. Please also keep the tbllowing instructions in mind when installing in a closet or recessed area: • Consider allowing additional clearance 1"o1 installation and servicing. • Wall, door and floor molding may force additional clearances. • An additional inch of clearance is recommended to minimize noise transfer. • Consider space needed t_r companion appliances. • For closet installations, the picture below shows the minimum required ventilation openings t_r the door. A louvered door with comparable ventilation openings is also acceptable. 3 B' _ (7.6 cm) 48 t_2j (310 cm 2) ventilation hole _8 F_ (45.72 cm) (68.6 cm) /-- (76.1 cm) * Most installations require a minimum 5 1/2in. (14 cm) clearance behind the dryer for the exhaust vent with elbow. Leveling legs should be secured. All four legs are stably placed on the solid and even floor. If dryer is not level, laundry may not tumble properly and sensor will not detect the accurate humidity information. When adjusting leveling, please be cautious not to have serious injuries on your fingers and toes. 24*'2 (155 cm_).. (7.6 cm) ventilation hole (2.54cm) 29.96" (76.1 cm) (2.54cm) 0 '_ (0 cm) 27" _0" (68.6 cm) (0 cm) 7