LG LP1200DXR Owner's Manual - Page 10

HOW TO USE USING THE CONTROLS Control panel buttons shown. Operation using the remote control is the same, unless specifically noted. NOTE: The remote sensor is located next to the display on the control panel. POWER Press the POWER button to turn the air conditioner ON or OFF. When you turn the air conditioner on, an ascending tone will play and the display will show the set temperature and any special mode setting indicators. The air discharge on the front of the air conditioner will automatically open. When turning the air conditioner off, you will hear a descending tone and the air discharge on the front of the air conditioner will close. Any control settings such as Mode, Set Temperature, Auto Swing, etc. will be retained in memory when the power is off. NOTE:­When turned on after being unplugged, the air conditioner will automatically reset to COOL mode, with a temperature setting of 72°F. Any settings will need to be re-entered. Always point the remote at the sensor. The remote may not work if the sensor is in bright light or if there is not a clear path between the remote and the sensor. MODE Press the MODE button to select the operating mode (COOL, FAN, or DRY) for the air conditioner. The indicator lamp next to the selected mode will light. The default setting is COOL. Press the MODE button to change to FAN, press again to change to DRY, and again to return to COOL. Mode COOL FAN DRY Features Compressor runs and cools the room. Use the TEMP/TIMER L / M and FAN buttons to set the desired temperature and circulation fan speed. Fan circulates air but compressor does not run. Use the FAN button to set the desired fan speed. Dry mode is used to remove humidity from the room without additional cooling. Once the set temperature is reached, the compressor and circulation fan turns off and only the exhaust fan will run. Fan speed is pre-set and cannot be adjusted. 10