Lenovo 9704ALU Hardware Maintenance Manual - Page 116
Replacing the secondary hard disk drive
UPC - 883609915025
View all Lenovo 9704ALU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
10. Press down on the metal latch 2 and pivot in the drive cage into place. Slide it forward until it snaps into position. Note: There are two arrows, one on the upper drive cage and one on the hard disk drive cage, that are aligned when the hard disk drive is in the proper position. 11. Connect the power and signal cables to the hard disk drive. 12. Go to "Completing the FRU replacement" on page 117. Replacing the secondary hard disk drive This procedure provides instructions on how to replace the secondary hard disk drive. Important When a new hard disk drive is installed, a set of Product Recovery discs might be required. The set of Product Recovery discs enable the contents of the hard disk to be restored to the same state as when the computer was originally shipped from the factory. For more information on recovering factory-installed software, refer to "Recovering Software" in the User Guide. To replace the secondary hard disk drive: 1. Remove the computer cover. See "Removing the cover" on page 93. 2. Locate the secondary hard disk drive 5 . 3. Disconnect the signal and power cables from the hard disk drive. 4. Press the blue release button to release the hard drive cage from the chassis. 108 ThinkCentre Hardware Maintenance Manual