Lenovo 9704ALU Hardware Maintenance Manual - Page 119
Connect the signal and power cables to the drive.
UPC - 883609915025
View all Lenovo 9704ALU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
11. Connect the signal and power cables to the rear of the new hard disk drive. 12. Go to "Completing the FRU replacement" on page 117. Replacing an optical drive This procedure describes how to remove and replace an optical drive. 1. Remove the computer cover. See "Removing the cover" on page 93. 2. Disconnect the signal and power cables from the rear of the optical drive. 3. Press the release button and remove the optical drive out the front of the computer. Note: Notice that there is a spare retainer bracket 1 attached to the upper drive cage. 4. Remove the retainer bracket from the drive being replaced and install it on the new drive. 5. Slide the new optical drive into the bay from the front until it snaps into position. 6. Connect the signal and power cables to the drive. 7. Go to "Completing the FRU replacement" on page 117. Replacing the diskette drive This procedure describes how to remove and replace the diskette drive. 1. Remove the computer cover. See "Removing the cover" on page 93. 2. Remove the front bezel. See "Removing and replacing the front bezel" on page 94. 3. Disconnect the signal and power cables from the rear of the diskette drive. 4. Press the release button and slide the diskette drive out the front of the computer. Chapter 9. Replacing FRUs (Types 7064, 7094, 9349, 9356, 9357, 9439, 9488, 9702, 9708, 9709, 9789, 9851, 9948) 111