Lenovo H430 Lenovo H4 Series Hardware Maintenance Manual V2.0 - Page 48

Replacing an optical drive

Get Lenovo H430 PDF manuals and user guides View all Lenovo H430 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 48 highlights

Hardware Maintenance Manual 6. Screw the four screws back into place in the drive bay. 7. Connect the power and data cables to the hard disk drive. Refer to "Identifying parts on the system board". 8. Refer to the "Completing the installation". Replacing an optical drive Attention Do not remove the computer cover or attempt any repairs before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at: http://consumersupport.lenovo.com To replace an optical drive 1. Remove the computer cover. Refer to "Removing the computer cover". 2. Remove the front bezel. Refer to "Removing and replacing the front bezel". 3. Disconnect the data and power cables from the rear of the optical drive. 4. Remove the two screws that secure the optical drive to the drive bay. 5. Push the optical drive straight out of the front of the chassis. 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
Hardware Maintenance Manual
46
6. Screw the four screws back into place in the drive bay.
7. Connect the power and data cables to the hard disk drive. Refer to
“Identifying parts on the system board”.
8. Refer to the “Completing the installation”.
Replacing an optical drive
Attention
Do not remove the computer cover or attempt any repairs before
reading the “Important safety information” in the
Safety and Warranty
Guide
that was included with your computer or in the
Hardware
Maintenance Manual (HMM)
for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at:
To replace an optical drive
1. Remove the computer cover. Refer to “Removing the computer cover”.
2. Remove the front bezel. Refer to “Removing and replacing the front bezel”.
3. Disconnect the data and power cables from the rear of the optical drive.
4. Remove the two screws that secure the optical drive to the drive bay.
5. Push the optical drive straight out of the front of the chassis.