Lenovo ThinkCentre M58e Hardware Maintenance Manual - Page 91

10. Press down on the metal latch 2 and pivot in the drive cage into place. Slide it forward until it snaps into position. Note: There are two arrows, one on the upper drive cage and one on the hard disk drive cage, that are aligned when the hard disk drive is in the proper position. 11. Connect the power and signal cables to the hard disk drive. 12. Go to "Completing the FRU replacement" on page 95. Replacing the secondary hard disk drive Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support Important When a new hard disk drive is installed, a set of Product Recovery discs might be required. The set of Product Recovery discs enable the contents of the hard disk to be restored to the same state as when the computer was originally shipped from the factory. For more information on recovering factory-installed software, refer to "Recovering Software" in the User Guide. This section provides instructions on how to replace the secondary hard disk drive. To replace the secondary hard disk drive: 1. Remove the computer cover. See "Removing the computer cover" on page 69. 2. Locate the secondary hard disk drive 5 . 3. Disconnect the signal and power cables from the hard disk drive. 4. Press the blue release button to release the hard drive cage from the chassis. Chapter 8. Replacing FRUs (Types 7258, 7260, 7268, 7270, 7280, 7296, 7298, 7304, 7307,7413, 7491, and 7508) 85