Lenovo ThinkPad X200 Hardware Maintenance Manual - Page 50
Beep symptoms, Table 3. Error messages continued, Table 4. Beep symptoms - fan error
View all Lenovo ThinkPad X200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Table 3. Error messages (continued) Symptom or error Failing bits: nnnn. Invalid system configuration data. I/O device IRQ conflict. Hibernation error. Fan error. Thermal sensing error. Cannot boot from any device. FRU or action, in sequence 1. DIMM. 2. System board. 1. DIMM. 2. System board. 1. Load "Setup Defaults" in the BIOS Setup Utility. 2. Backup battery. 3. System board. 1. Restore the system configuration to what it was before the computer entered hibernation mode. 2. If memory size has been changed, re-create the hibernation file. 1. Fan. 2. Thermal grease. 3. System board. System board. Check the status of device which you want to boot from. Device not found. 1. The device you want to boot from. 2. System board. Device Error. 1. The device you want to boot from. 2. System board. No valid operating system. 1. Check that the operating system has no failure and is installed correctly. 2. Reinstall the operation system. Excluded from boot order. • Enter the BIOS Setup Utility and add the device in boot order. Beep symptoms Table 4. Beep symptoms Symptom or error One beep and a blank, unreadable, or flashing LCD. FRU or action, in sequence 1. Reseat the LCD connector. 2. LCD assembly. 3. External CRT. 4. System board. One long and two short beeps, and a blank or unreadable LCD. 1. System board. 2. LCD assembly. 3. DIMM. Two short beeps with error codes. POST error. See "Numeric error codes" on page 39. 44 Hardware Maintenance Manual