Lenovo ThinkServer Storage SA120 (English) User Guide and Hardware Maintenance - Page 40

• RAID 5: block-level striping with distributed parity RAID 5 uses disk striping and parity data across all drives (distributed parity) to provide high data throughput, especially for small random access. RAID 5 distributes parity along with the data and requires all drives but one to be present to operate; drive failure requires replacement, but the array is not destroyed by a single drive failure. Upon drive failure, any subsequent read operations can be calculated from the distributed parity so that the drive failure is masked from the end user. The array will have data loss in the event of a second drive failure and is vulnerable until the data that was on the failing drive is rebuilt onto a replacement drive. A single drive failure in the set will result in reduced performance of the entire set until the failing drive has been replaced and rebuilt. RAID 5 requires a minimum number of three hard disk drives. • RAID 6: block-level striping with distributed parity RAID 6 uses distributed parity, with two independent parity blocks per stripe, and disk striping. A RAID 6 virtual drive can survive the loss of any two drives without losing data. A RAID 6 drive group is similar to a RAID 5 drive group. Blocks of data and parity information are written across all drives. The parity information is used to recover the data if one or two drives fail in the drive group. RAID 6 requires a minimum number of four hard disk drives. • RAID 10: a combination of RAID 0 and RAID 1 RAID 10 consists of striped data across mirrored spans. A RAID 10 drive group is a spanned drive group that creates a striped set from a series of mirrored drives. RAID 10 allows a maximum of eight spans. You must use an even number of drives in each RAID virtual drive in the span. The RAID 1 virtual drives must have the same stripe size. RAID 10 provides high data throughput and complete data redundancy but uses a larger number of spans. RAID 10 requires a minimum number of four hard disk drives and also requires an even number of drives, for example, six hard disk drives or eight hard disk drives. • RAID 50: a combination of RAID 0 and RAID 5 RAID 50 uses distributed parity and disk striping. A RAID 50 drive group is a spanned drive group in which data is striped across multiple RAID 5 drive groups. RAID 50 works best with data that requires high reliability, high request rates, high data transfers, and medium-to-large capacity. Note: Having virtual drives of different RAID levels, such as RAID 0 and RAID 5, in the same drive group is not allowed. For example, if an existing RAID 5 virtual drive is created out of partial space in an array, the next virtual drive in the array has to be RAID 5 only. RAID 50 requires a minimum number of six hard disk drives. • RAID 60: a combination of RAID 0 and RAID 6 RAID 60 uses distributed parity, with two independent parity blocks per stripe in each RAID set, and disk striping. A RAID 60 virtual drive can survive the loss of two drives in each of the RAID 6 sets without losing data. RAID 60 works best with data that requires high reliability, high request rates, high data transfers, and medium-to-large capacity. RAID 60 requires a minimum number of eight hard disk drives. For detailed information about RAID, refer to "Introduction to RAID" in the MegaRAID SAS Software User Guide on the documentation DVD that comes with your storage array. Configuring the advanced SATA/SAS hardware RAID The MegaRAID Storage Manager program helps you manage the RAID array and RAID controller in an operating system environment. For instructions on how to configure and manage the advanced SATA/SAS hardware RAID, refer to the MegaRAID SAS Software User Guide on the documentation DVD that comes with your storage array. This document also is available on the Lenovo Web site at: http://www.lenovo.com/UserManuals 28 ThinkServer Storage SA120 User Guide and Hardware Maintenance Manual