Lexmark Dot Matrix Technical Reference - Page 104
Settings, The next example shows an alternative way to con OS/2.
View all Lexmark Dot Matrix manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
1 Select the printer icon. 2 Select Open. 3 Select Settings. The Printer - Settings screen appears. 4 Select the serial port to which you want to attach the printer. The Serial Port - Settings screen appears. 5 Select the settings you want to use. 6 Select OK. The next example shows an alternative way to configure OS/2. From the OS/2 prompt, enter the following command: mode com1:9600,n,8,1,,DTR=on,OCTS=on,ODSR=on You can also include the following command statement in the CONFIG.SYS file on your computer so that it runs each time you start your computer: run c:\os2\mode.com com1:,,,,,DTR=on,OCTS=on,ODSR=on 104 Section 6: Using the Printer Interface
Section 6: Using the Printer Interface
104
1
Select the printer icon.
2
Select
Open
.
3
Select
Settings
. The Printer - Settings screen appears.
4
Select the serial port to which you want to attach the printer. The Serial
Port - Settings screen appears.
5
Select the settings you want to use.
6
Select
OK
.
The next example shows an alternative way to configure OS/2.
From the OS/2 prompt, enter the following command:
mode com1:9600,n,8,1,,DTR=on,OCTS=on,ODSR=on
You can also include the following command statement in the CONFIG.SYS file
on your computer so that it runs each time you start your computer:
run c:\os2\mode.com com1:,,,,,DTR=on,OCTS=on,ODSR=on