Lexmark Dot Matrix Technical Reference - Page 181
the Data Transfer Command. Five characters are defined in the data trans
View all Lexmark Dot Matrix manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
• The desired barcode may not print if the number of characters specified by n1, n2 does not match the required number for the desired barcode type. Example: 45678 ... The desired barcode type is EAN-13 (B2). The check digit is generated by the host/software (b0=0). This means there must be 13 data characters in the Data Transfer Command. Five characters are defined in the data transfer command; this conflicts with the required number of 13. Section 8: Barcodes 181
181
Section 8: Barcodes
•
The desired barcode may not print if the number of characters specified by
n1
,
n2
does not match the required number for the desired barcode type.
Example:
The desired barcode type is EAN-13
(B2
). The check digit is generated by
the host/software (b0=0). This means there must be 13 data characters in
the Data Transfer Command. Five characters are defined in the data trans-
fer command; this conflicts with the required number of 13.
<x
1B5B66
-
barcode setup command prefix
0600
-
setup data length (low byte first) -
x0006, 6
B2
-
barcode type = EAN-13
00
-
module width = default
00
-
space width adjustment = default
3002
-
height (low byte first) - x0230 = 0.259
inches
00
-
control byte: check digit by host,
print human readable character, center
flag character
1B5B70
-
barcode data transfer command prefix
0500
-
data transfer length (low byte first)
- x0005, 5
>45678 ...